Knowledgebase
Creating Dimensions and Hatch on a Separte Layer
Posted by Christian Kramer on 2018-12-12 13:47

Dimensions and hatches can be created on a specific, separate layer automatically, when the corresponding system variables DIMLAYER and HPLAYER have been set to it before command execution.

 

(0 vote(s))
This article was helpful
This article was not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please enter the text you see in the image into the textbox below. This is required to prevent automated registrations and form submissions.